Change Within The Mode - Denon S-52 DAB Service Manual

Q Q

4.4. Change within the mode

3 7 6 3 1 5 1 5 0
Changes within modes are made by pressing the
In the laser on/off mode, laser on/off control is executed and the laser current is displayed.
For the CD laser
( : Off, CD laser, Stored data: mm.mm [mA], Current value: nn.nn [mA])
When there is no saved data
( : Off, nn.nn [mA])
To store the current value, press the button for "
/
select T23.
If the button is pressed while T23 is displayed, the current value is displayed at "mmmm" and stored in the EEPROM.
/
( : Off, nn.nn [mA])
If the current value is over 100 mA, the 4th and 9th digit sections are used.
In the servo adjustment value display mode (See "Table 1 - Servo adjustment value display mode details")
(XX : Selection mode, n: Adjustment value (HEX))
For the adjustment values, 0's are added in front of the effective number of bytes.
T E
L 1 3 9 4 2 2 9 6 5 1 3
(Ex.: If the value is 0x123 for 4-byte data, "00 00 01 23" is displayed.)
In the trace mode (error rate display) (See "Table 2 - Trace mode details")
(YY : Selection mode [71 to 94], F: When address and error rate not set, F is displayed.)
In the accumulated laser on time display
(nnnnnnn: Time [h]) If the current value is over 100 mA, the 4th and 9th digit sections are used.
To clear the accumulated laser on time, press the
/
appears at the fourth position, then the accumulated laser on time of CD is cleared.
When TB1 is selected, "nnnnnnn" is displayed as 0 so you can check.
w w w
.
and buttons while the mode is set.
" appears at the fourth position, then press the or
button while the accumulated laser on time is displayed (TB1) until "
x a o
y
i
http://www.xiaoyu163.com
8
button to
Q Q
3 7 6 3
"
u 1 6 3
.
34
http://www.xiaoyu163.com
9 2 4 9 8
/
/
1 5 1 5 0 8 9 2 4
m
c o
S-52/S-52DAB/S-32
2 9 9
9 8 2 9 9
/