Table of Contents
Advertisement
3 Testing PROFINET / Ethernet cable
BEFORE TESTING STARTS, INSPECT THE PLUGS OF THE CABLE.
Improperly crimped or damaged plugs can harm the jacks of the cable tester. Do NOT use 6-pin
(phone) plugs with the 8-pin RJ 45 jack.
Take out the Remote Unit of the main unit (squeeze remote at finger grip openings in main
unit to remove it).
The Remote Unit has to be placed on the other side of the cable. If the cable is short or both ends are
very close to each other, the Remote Unit can be left in the main unit.
PN1-Manual-EN.docx
Fig. 3 - Taking out the Remote Unit
_______________________________________________
Version 1.2.1 – June 2014
PROFINET Cable Tester – User Manual
© PROCENTEC 2014 - Copyright - all rights reserved
Page 11 / 32
Advertisement
Table of Contents
