Replacing The Hard Disk Drive Or Solid-State Drive - Lenovo ThinkPad T540p User Manual

6. Place the notched end of the new memory module toward the contact edge side of the memory slot,
and insert the memory module into the memory slot at an angle of about 20 degrees
memory module downward until it snaps into place
in the memory slot and cannot be moved easily.
Attention: Do not touch the contact edge of the memory module. Otherwise the memory module
might be damaged.
Note: If you install only one memory module, install it into the bottom slot.
7. Reinstall the large bottom cover
8. Reinstall the battery pack. See "Replacing the battery pack" on page 77.
9. Turn the computer over again. Connect the ac power adapter and all cables to the computer.

Replacing the hard disk drive or solid-state drive

Before you start, print these instructions.
Attention: The hard disk drive or solid-state drive is very sensitive. Incorrect handling can cause damage
and permanent loss of data. Observe the following guidelines:
2
. Ensure that the memory module is firmly installed
1 2 , and then tighten the screws
1 . Pivot the
3 .
.
Chapter 6 Replacing devices
85