Advertisement
Wires
Hex Nut
Washer
Switch Housing
If you are going to use an RM-08 Control Unit
Forward/Reverse
Switch
with this fan, refer to the Installation Manual
for the RM-08 before proceeding further.
Step 10 Electrical Switch Housing Installation
Nipple
Back off (loosen) the three screws on the electri-
cal housing mounting plate attached to the motor
shaft (see figure 14).
Remove the center cap on switch housing by
pushing on the inside of switch housing.
Feed wires from fixture through center hole on
switch housing.
Thread nipple on top of fixture into switch hous-
ing. Hand tighten, and secure with hex nut from
Fixture
inside switch housing (see figure 15).
A color coded wire connector (female) is located
Fig. 15
inside the electrical switch housing (see figure
16), a male connector extends from the mounting
plate. Align the colors on each connector and
push them together. The connectors are also
notched and will connect only when the colors
are aligned.
Connect the single wire from fan to the single
plug in Switch Housing Unit.
Switch
Motor
Housing
The switch housing has three slotted holes
Housing
Connector
Connector
around the top. Align these holes with the three
screws on the mounting plate. Push the switch
housing up and rotate the the right so the screws
are at the far left of the horizontal slot.
Fig. 16
Tighten each screw.
9
Advertisement
