Advertisement
Fig. 11
Screw
Washer
Blade Arm
Fig. 12
Step 7 Attaching the Ceiling Canopy,
Slide the ceiling canopy up into place over the
ceiling mounting bracket. Slide rubber canopy
cover into place. The two screws on the mount-
ing bracket face should slip through the key hole
slots in the canopy (see figure 11).
Depending on how deep the
electrical junction box was
installed in the ceiling, you
may have a slight gap
between the ceiling canopy
and the ceiling.
Junction boxes are commonly installed at differ-
ent depths in the ceiling, so we have designed
the mounting bracket and canopy to allow for
this
Step 8 Fan Blade and Blade Arm Assembly
Most CONCORD fans are supplied with a
reversible blade finish. Choose the blade finish
that you prefer and attach as follow:
Attach each fan blade to a blade arm with four (4)
3/16" x 1/2" washer head screws and four (4)
3/16" screw pads (see figure 12). DO NOT
OVER TIGHTEN THESE SCREWS.
Screws should be tightened until the screw pads
are compressed by the screw head. Hold the
Blade Arm decorative side down and place the
blade on top with the flat side of the blade facing
down. Each screw is passed through the screw
pad and blade and screwed into the blade arm.
7
Advertisement
