Front Panel - Kustom Sienna35 Owner's Manual

Kustom owners manual amplifier sienna35
Table of Contents

Advertisement

MIC/LINE
MIC/LINE
GUITAR
MIC/LINE
INPUT
INPUT
MIC
LINE
Mic/Line Input Jack:
T
his is a 1/4" 2-conductor input jack for plugging in a Hi-Z
microphone or instrument. It is intended for microphones but
will accept other instruments as well.
Guitar Input Jack:
This is a 1/4" 2-conductor input jack for plugging in your
instrument. It is intended for guitar or Hi-Z microphones but
will accept other instruments as well.
Mic/Line Volume Control:
This control is used to adjust the output volume for the mic/line
input. Slowly increase the control to increase the volume. If you
are using a high impedance microphone, be careful when
increasing the volume. Depending on mic position, it may
feedback if the mic is in front of the speaker.
Mic/Line Input Switch:
This switch will select a mic or line input level.
Guitar Volume Control
:
This control is used to adjust the output volume for the guitar
input. If you are using a guitar with an on-board preamp, set it's
level for a mid position before increasing this control; otherwise
distortion may occur.
Guitar Active/Passive Switch:
This switch will place a -20dB pad in the circuit, which will
allow use of active on-board electronics from pre-amplified
guitars. This will help keep the signal extremely clean.
Frequency Control
:
This control is a tight Hi-Q cut filter notch with an extremely
narrow width. It sweeps between 50Hz and 500Hz and "fine
tunes" the midrange of the acoustic guitar. This helps eliminate
unwanted "ringing" tones. The level is preset to -10dB.
Low Control
:
This control is the bass control. It is active and set to boost or
cut frequencies at 60Hz. This will effect the low frequency
signals. Turning it counterclockwise, the low will be rolled off -
18dB. Clockwise, it will boost +18dB. Especially good for
"cleaning up" preset patches or making thin toned guitars sound
fuller.
Mid Control
:
This control is the midrange control. It is active and set to boost
or cut frequencies at 1.5KHz. This will effect the mid-low
frequency signals.
Turning it counterclockwise, the low-mids
will be rolled off -18dB. Clockwise, it will boost +18dB.
Especially good for "cleaning up" guitar overtones.

Front Panel

FREQUENCY
GUITAR
LOW
GUITAR
INPUT
INPUT
PASSIVE
ACTIVE
MID
HIGH
LEVEL
EFFECTS
3
ON
OFF
High Control
:
This control is the high frequency tone control. It is active and
set to boost or cut frequencies at 5KHz. This will effect the high
frequency signals. Turning it counterclockwise, the highs will
be rolled off -18dB. Clockwise, it will boost +18dB. This will
add or subtract the high end shimmer and clarity.
Effects On/Off Switch:
This switch engages the digital effects section.
Effects Level Control:
This control adds the digital effects section and mixes it into the
main signal buss. Several different effects are available.
Program Select Switch:
This switch will select any of eight different effects.
Jewel Light:
This jewel light lets you know that the amplifier is on.
Power Switch:
This switch turns on and off the AC power to the amp.
Back Panel - (not pictured)
Speaker Out:
This is a 2 conductor 1/4" speaker output jack. This will
disconnect the internal speaker and allow an
speaker cabinet to be employed. Rating is 8 ohms.
Line Output:
This is a 2 conductor 1/4" line output jack. This will allow an
external amplifier or mixing board to be supplied with the signal
from this amp. This signal is attenuated and comes from the
power amp.
Headphone Jack:
This is a 1/4" 3 conductor jack for plugging headphones. It will
sum the signal and put the sound in both ears, thereby creating a
pseudo-stereo sound. Volume will be determind by the volume
control on the channel you are on. It will disconnect the internal
speaker when plugged in. This will allow quiet practicing.
Footswitch:
This is a mono 1/4" jack. Plug a single non LED type footswitch
(optional) into this jack to turn the digital effects on and off.
4
PROGRAM
5
1. BRIGHT ROOM
4
6
2. MELLOW ROOM
3. BRIGHT HALL
4. MELLOW HALL
7
5. CHORUS
6. CHORUS/ROOM
8
2
7. CHORUS/HALL
1
8. SLAPBACK
external

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sienna 35

Table of Contents