Front Panel; Tuner Out; Mute On/Off Mute - Kustom GROOVE 1300 Owner's Manual

-12 dB
NORM
Input Jack:
T his is a 1/4" 2-conductor input jack for plugging
in your instrument using a shielded instrument
cable. It is intended for bass guitar but will accept
other instruments and line level signals as well
NORM/-12 dB Switch
Set this switch to -12 dB when using an active
bass guitar or line level signals. Setting to -12 dB
will lower the input gain by 12 dB.
Gain Control:
Controls the amount of input to the preamp
Adjust so indicator illuminates when notes
SIG
are played .
Clip Indicator:
Indicates when the input signal has reached
maximum level. If indicator illuminates when
notes are played , set
NORM/-12 dB
-12 dB and/or turn down
Signal Indicator :
Indicates when sufficient signal is applied to the
preamp. Adjust control so indicator
GAIN
illuminates when notes are played
Mute Indicator :
This red LED will blink indicating all outputs are
muted except for the

TUNER OUT

#26). Muting can be done by either depressing the
switch on the front panel or by
MUTE ON/OFF
pressing on the footswitch.
MUTE
Mute On/O Switch:
When t
his switch is depressed, all outputs are
muted except for the
TUNER OUT
#26). Using footswitch overrides this
Note:
switch.
Bass Control:
Controls the amount of low frequency in the signal.

Front Panel

120Hz 700Hz 3kHz
55Hz 350Hz 4kHz
FLAT FLAT FLAT
-6dB +6dB -6dB +6dB -6dB +6dB
-12dB +12dB -12dB +12dB -12dB +12dB
.
.
switch to
control.
GAIN
.
(rear panel
(rear panel
®
Mid Control:
Controls the amount of midrange frequency in the
signal.
High Control:
Controls the amount of high frequency in the signal.
120Hz/55Hz Switch:
This switch selects
frequency of the
70 0Hz/350Hz Switch:
This switch selects
frequency of the
3kHz/4kHz Switch:
This switch selects
frequency of the
Graphic Equalizer Section:
This 9-band graphic equalizer is used to adjust the
sound to the room acoustics.
finely adjust sound to taste.
Master Volume Control:
Controls the overall output of the amplifier. Use in
conjunction with the
desired speaker output.
Power Switch:
Turns AC power on and off.
first applied, there is a slight delay before sound is
heard through the speakers.
Solo Indicator:
This blue LED is lit when the
been activated.
Solo On/O Switch:
depressed, activates SOLO mode. When active,
the signal to the power amp will be boosted by 6dB.
Power Jewel:
Indicates when AC power is applied to the
amplifier.
6
or for the center
120Hz 55Hz
BASS Control.
or for the center
700Hz 350Hz
MID Control.
or for the center
3kHz 4kHz
HIGH Control.
It may also be used to
control to obtain
GAIN
When power is
Note:
mode has
SOLO
T
his switch when