Superior VRT2536WS Installation And Operation Instructions Manual page 14

Model VRT3542WS Shown
Firebox
floor
Loose knot in power
cord to take up slack
Figure 22
Model VRT3542WS
Cabinet Base
Figure 21 -
VRT3542WS Shown
Bend Locating Tabs Over
Figure 24 -
VRT3542WS Shown
step 6. Route a 3-wire, 120 VAC, 60 Hz, 1 ph power supply to the right
side of appliance.
step 7. Locate the J-Box cover (provided in J-Box Kit). Remove the round
knock-out (see Figure 19).
14
Locating Tabs
(into notches)
NOTE: DIAGRAMS & ILLUSTRATION ARE NOT TO SCALE.
step 8. Ensure that power supply wires are Not "live" before making
these connections). Install j-box cover Plate as follows:
Feed the * Romex wires (or other equivalent plastic insulated
wire - Refer ANSI/NFPA 70 - National Electrical Code - Latest
Edition) through the J-Box Cover retangular opening, then con-
nect to the J-box wires. The strain relief bushing (not supplied)
should be pressed into the knock-out on J-box cover around the
Romex (this will provide protection to the wires and prevents strain
against connections from J-box). See Wiring Diagram - Figure
16. Install the cover plate over J-Box opening on appliance as
shown in Figure 25.
Note: Wire connections should be positioned inside of the ap-
pliance.
* Romex is a plastic insulated wire from power supply - sometimes called
non-metallic sheath.
Right Side Panel of Firebox
Use screw provided and
secure in place as shown
Screw
Figure 25 -
Installing J-box Cover Plate - All Models
step 9. Follow the instructions below for the kit you are installing:
FBK-100Kits-Installafield-provided(orP/N85L87)ON/OFFwall
switch in a convenient location on a wall, near the fireplace.
FBK-200Kits-Installthekit-providedvariablespeedcontrol(rheo-
stat) in a convenient location on a wall, near the fireplace.
step 10. Follow the instructions below for the model you are installing:
model VRt2536Ws:
Reinstall the blower access panel that was removed on Step 1 (see
Figure 18).
models VRt3536Ws, VRt3536Wh, VRt3542Ws & VRt3542Wh:
Reinstall the bottom refractory panel that was removed on Step 1
(see Figure 17).
J-Box opening
on appliance
The notched side of
cover plates goes inside
firebox panel
Cover Plate