Superior VRT2536WS Installation And Operation Instructions Manual page 13

Installation Instructions -
FBK-100 or FBK 200 Blower Kits and JBK Junction Box Kit
ImPoRtANt
All electrical wiring must be performed by licensed Elec-
tricians. Electrical wiring must comply with the National
Electrical code ANsI/ NFPA 70 - latest edition
step 1. Follow the instructions below for the model you are installing:
model VRt2536Ws:
Using a screwdriver remove the screw from the blower access panel
as shown in Figure 18. Slide the panel to the right until the flange
clears the opening. Remove the panel and set aside.
models VRt3536Ws, VRt3536Wh, VRt3542Ws & VRt3542Wh:
Lift out the bottom refractory panel (see Figure 17).
step 2. Remove the rectangular knock-out (for J-Box) on the right side
of unit (see Figure 8 for location). Install the Junction Box & Electrical
outlet below the firebox floor into the rectangular opening on the right
side cabinet panel where you removed the knock-out (see Figures 20 &
21). The Junction Box / Electrical Kit is sold separately (see Page 15 for
ordering information).
• Squeeze the J-Box flanges together to fit into the opening shown in
Figures 20 and 21.
• Wires will need to be passed through the hole shown in Figure 19.
• Anapprovedstrainreliefbushing(notsuppliedwiththekit),isrequired
to restrain the wires (see Figure 19).
step 3. Loosely tie a knot in the power cord to take up slack (see Figure 22).
step 4. Locate the tabs shown in Figure 23. Position the blower assembly
so that the tabs (located on the cabinet base) are seated in the notches of
the blower bracket. Bend the tabs over to secure the blower assembly (see
Figure 24).
step 5. Plug power cord into the electrical outlet as illustrated in Figure 15.
Lift Out Bottom Refractory Panel
models: VRt3536Ws,
VRt3536Wh, VRt3542Ws
& VRt3542Wh
Figure 17
Firebox
floor
Blower
Access
Panel
Remove screw, then lift out blower access panel.
Figure 18 -
Model VRT2536WS
screw
NOTE: DIAGRAMS & ILLUSTRATION ARE NOT TO SCALE.
cover Plate
Remove knock-out
(strain relief bush-
ing [not supplied]
presses into this
hole around romex
wires - see Step 8 on
Page 14).
screw
Figure 19 -
Junction Box Kit (all models)
j-box & Electrical outlet
Firebox
floor
Install into side wall rectanular opening
Figure 20 -
Model VRT3542WS Shown
Right Outside Cabinet Panel
j-box Flanges
Wires
Figure 21
j-box &
Receptacle
j-box Flange
j-box &
Electrical
outlet
13