Model
Output Power, Both Channels
Driven
Accepted Inputs
Frequency Response
Total Harmonic Distortion
Hum & Noise
System Gain per Channel
Input Channel Equalization
Master Equalization
Sub Woofer
Digital Effects
Phantom Power
Power Requirements
Dimensions & W eight
Model
Power Capacity
Frequency Response
Nominal Impedance
Dimensions & W eight Per
Cabinet
Profile System Two
Specifications
KPS-PM300
6 Channel Dual Powered Mixer
145W per channel
4 Ohms @ 0.1% THD
150W per channel
4 Ohms @ 1% THD
170W per channel
4 Ohms @ 5% THD
CH 1 - 4
Mic XLR Balanced, Line 1/4" Balanced/Un-balanced
Mic XLR Balanced, Line 1/4" Un-Balanced Mono or
CH 5
Stereo, Hi-Z instrument Un-Balanced Mono
Mic & line 1/8" stereo, RCA Stereo. Any combination
Aux
of these inputs can be used at once.
Actual response is tailored to speaker cabinet for
20HZ-20kHz
accurate acoustical response.
Measured at 1VRMS (0dBv) at record output, preamp
Less than 0.4%
output, or monitor output.
-110 dB
Mic Input, Rs=150 ohm, 20-20kHz
-60dB
Residual Noise, all level controls 0% (minimum)
-55dB
Nominal System Noise, all level controls at 50%
All Measurements made at 1kHz unless noted
+70dB
Mic to Speaker Output (Ch 1 - 5)
+70dB
Mic to Speaker Output (Aux)
+50dB
Line to Speaker Output (CH 1 - 5)
+50dB
Stereo Line to Speaker Output (CH 5)
+45dB
Line to Speaker Output (Aux)
+40dB
Mic to Sub Output ( measured using 80Hz)
+40dB
Mic to Preamp Output
+40dB
Mic to Monitor out
+40dB
Mic to Record out
+30dB
Power amp in to Speaker Output
Special curve that adjusts Bass and Treble frequencies
100 to 10kHz, 7 Band, 1 Octave Graphic, all ±12dB
120Hz fixed, Low Pass
24 bit DSP 16 preset stereo digital effects taylored for PA applications.
+40V
Mic inputs (Ch 1 - 5)
+5V
Mic input (Aux)
USA/Canada
120VAC/60Hz, 200W nominal
Europe
230VAC/50Hz, 200W nominal
UK
230VAC/50Hz, 200W nominal
Australia
240VAC/50Hz, 200W nominal
Japan
100VAC/50-60Hz, 200W nominal
mm/kg
345 (Height) x 252 (Width) x 290 (Depth), 11 kg
Inches/Pounds
13.6 (Height) x 10 (Width) x 11.5 (Depth), 24.2 lbs
KPS-LS300
Profile System Two Loudspeaker System
150W each
EIA RS-426
300W each
Program Power (music power)
60HZ-20kHz
+/- 3dB
4 Ohms
Per Cabinet, Accurate acoustical response
mm/kg
542 (Height) x 272.2 (Width) x 290 (Depth), 11.6 kg
Inches/Pounds
21.4 (Height) x 10.75 (Width) x 11.5 (Depth), 25.5 lbs
18
Need help?
Do you have a question about the Profile System Two and is the answer not in the manual?