Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Bindicator InvisiLink
Summary of Contents for Bindicator InvisiLink
- Page 1 InvisiLink Wireless Radio ™ Installation & Operation Manual...
-
Page 3: Table Of Contents
InvisiLink Wireless Radio Installation & Operation Manual CONTENTS HANDLING AND STORAGE ........................1 INSPECTION AND HANDLING DISPOSAL AND RECYCLING STORAGE II. GENERAL SAFETY ........................... 2 AUTHORIZED PERSONNEL MISUSE III. PRODUCT DESCRIPTION ........................3 FUNCTION FEATURES TECHNICAL SPECIFICATIONS IV. MECHANICAL INSTALLATION ......................... 4 V. - Page 4 SAFETY SYMBOLS WARNING: IDENTIFIES CONDITIONS OR PROCEDURES, WHICH IF NOT FOLLOWED, COULD RESULT IN SERIOUS INJURY. RISK OF ELECTRICAL SHOCK. CAUTION: IDENTIFIES CONDITIONS OR PROCEDURES, WHICH IF NOT FOLLOWED, COULD RESULT IN SERIOUS DAMAGE OR FAILURE OF THE EQUIPMENT.
-
Page 5: Handling And Storage
InvisiLink Wireless Radio HANDLING AND STORAGE SAVE THESE INSTRUCTIONS INSPECTION AND HANDLING Do not dispose of the carton or packing materials. Each package should be inspected upon receipt for damage that may have occurred due to mishandling during shipping. If the unit is received damaged, notify the carrier or the factory for instructions. Failure to do so may void your warranty. -
Page 6: General Safety
GENERAL SAFETY AUTHORIZED PERSONNEL All instructions described in the document must be performed by authorized and qualified service personnel only. Before installing the unit, please read these instructions and familiarize yourself with the requirements and functions of the device. The required personal protective equipment must always be worn when servicing this device. -
Page 7: Product Description
PRODUCT DESCRIPTION FUNCTION InvisiLink is a wireless radio solution for devices that communicate via RS-485 or RS-422. A radio is connected to both the measuring device, like a Yo-Yo or controller, and the receiving device, like an ORB. Then the InvisiLink radio sends data back and forth between the devices. -
Page 8: Mechanical Installation
CAUTION: DO NOT ROUTE SERIAL CABLES IN THE SAME CONDUIT WITH AC POWER CABLES. MOUNTING CONSIDERATIONS: • Mounting hardware is not supplied by Bindicator. • When mounting the enclosure ensure there is enough clearance to open the front door completely. - Page 9 TO MOUNT THE INVISILINK ENCLOSURE 1. Hold the enclosure against the wall in the desired location and mark the positions of the mounting holes. Place the enclosure in a safe location. 2. Drill the mounting holes in the wall.
-
Page 10: Electrical Installation
RS-485/RS-422 EQUIPMENT MATRIx COMMUNICATION DEVICE RS-485 RS-422 Bindicator 3D Level Scanner Bindicator Mark-4/GP-4 Yo-Yo Bindicator/Kistler-Morse ORB Bindicator/Kistler-Morse ORB 4-20mA Input Box Bindicator SonoTracker Kislter-Morse Ultrawave Kistler-Morse MVS Kistler-Morse STXplus Kistler-Morse SVS2000 Kistler-Morse Weigh II Niagara Meters 5600 Controller Note: RS-485 Communication will be programmed at a baud rate of 115200;... - Page 11 Figure 2: Wiring Diagram RS-422 Figure 3: Wiring Diagram RS-485 (MODBUS) WIRING DIAGRAM RS-485 (MODBUS) WIRING DIAGRAM RS-422 POWER BOARD POWER BOARD WIRELESS BOARD WIRELESS BOARD 4 3 2 4 3 2 9 8 7 6 9 8 7 6...
- Page 12 WIRING DIAGRAM RS-422 W/4-20 Figure 4: Wiring Diagram RS-422 with 4-20 mA Input Box This Power Board is mounted under the Wireless Board to the right. The (2) boards are shown side-by-side for clarity. Ch. 4 Ch. 3 Ch. 2 Ch.
-
Page 13: Set-Up
VI. SET-UP At this point, all radio enclosures should be mounted into place and wired appropriately. The radios should automatically begin sending and receiving signals. NOTE: Communication device types cannot be mixed. RS-485 devices must be connected to another RS-485 device;... -
Page 14: Maintenance
Extended Range Antenna, 10 ft (3 m) Connection Cable LUC044005 Extended Range Antenna Lightening Arrestor VIII. TROUBLESHOOTING For technical or service questions, please call the manufacturer Customer Support at 1-800-778-9242. For detailed dimensional drawings, go to www.bindicator.com. SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION Radio(s) are not powered on Make sure the Indicator LED is red;... - Page 15 NOTES WRL180213 Rev. A...
- Page 16 150 Venture Boulevard Spartanburg, SC 29306 Tel: (800) 778-9242 2014 All rights reserved. Fax: (864) 574-8063 All data subject to change without notice. sales@bindicator.com www.bindicator.com WRL180213 Rev. A...