Pair With Your Speed And Cadence Sensor - velomann VDOUBLE 10 User Manual

2-2 Pair with Your Speed and Cadence Sensor

1. In standby mode, press to point to PAIRING SENSOR, press to enter.
2. Press to point to PAIRING BIKE, press to create Bluetooth connection and start pairing.
3. Paired successfully, message OK prompts, press to exit. Pairing failed, message NO-DEV prompts, press to exit to PAIRING BIKE and starts
from STEP 2 again.
Please refer to the Speed and Cadence Sensor manual to install the sensor and its included magnet to your bike, turn the crank counterclockwise until the sensor is connected to the
Cycling Computer and the "OK" message prompts.

Make sure SPD/CAD is set to ON in the Sensor Setup window. (Page 15)

Activate your Speed and Cadence Sensor before pairing by cranking to start the sensor and establish connection. Your Speed and Cadence Sensor remains awake for one
minute. It goes back to sleep mode again if no Bluetooth connection is enabled.

Keep your Speed and Cadence Sensor and Cycling Computer close to each other and away from other Bluetooth devices for correct pairing.