Chapter 0 Preparation job before configuration 0.1 Learn your router version and feature 1) H700 series contains different version and option feature. Please learn it before using it. H700 series defines the model as follows, E‐Lins Technology Co.,Limited Tel: +86‐755‐29230581 E‐mail: sales@e‐lins.com sales@szelins.com www.szelins.com ...
H700_Datasheet_Eng.pdf 1.3 Notice The copyright of the document belongs to E-Lins Technology Co., Limited. Copying of this document and modifying it and the use or communication of the contents thereof, is forbidden without express. Authority, Offenders are liable to the legal sanction.
2 Introduction 2.1 Brief H700 Series Router is easy to install, reducing the Reliance on the end customer and enables direct access to your remote LAN devices for control and monitoring purposes, it enables companies to remotely access equipment at mobile, remote networks and isolated sites.
The H700 series cellular Router is configured using a web browser as the interface. To log-on to the web server, enter the IP address of the 3G cellular Router in the browser address window. The default address is 192.168.0.254:10000.
Set the parameters as above. a. Config Operation mode as “AP”; b. Config SSID as you want, for example, “E-Lins Router” c. You can set the Encryption mode for “psk, psk2” or “wep” or “None”; and set “key” as the WiFi Access Password;...
Chapter 8 8 DTU & GPS Setting 8.1 DTU Setting (serial to cellular feature) Notes: this feature is for H700 series with DTU feature only. Please skip this if your H700 router is without this feature. There are two kinds of applications.
For details of DTU setting, please contact us for further support. 8.2 GPS Setting Notes: this feature is for H700 series with GPS feature only. Please skip this if your H700 router is without this feature. Please config the right parameters as followed picture.
11.5 Signal Strength Check H700 series will use different type of module modem depends on customer’s requirement or our stock. Some module modem can show the signal strength in the “System Info” page of the router web page.
Very good 11.6 Keep alive feature The H700 series router supports watchdog. The watchdog avoid freezing for H700. Meanwhile, it built-in PPP checking and DNS checking features, it will automatically check dead-link or fake-link from the network. And besides, there is another IP checking feature to keep alive.
Here we just test the router’s DTU feature is working or not. We make H700 as DTU client, and get a PC to run a server tool software. Step 1) check if your device is RS232 or RS485 port, should be same with the H700 series router. Step 2) get the H700’s DTU feature right setted as follows, E‐Lins Technology Co.,Limited ...
Solution: 1. Check if the power adapter connector is loose from the router. 2. Try to replace a power adapter. H700 series router uses 9V1.5A or 9V2A or 12V1A or 12V1.5A or 12V2A power adapter with 2.5mm connector 3. Router hardware defeated. Send back to factory for check or repair.
2G or 3G only 12.4 DNS is wrong after dialup A. H700 series router can get the right DNS automatically once it’s dialup to be online. Please follow the steps to setup. Step 1): at router “WAN Setting”, please choose “Yes” at “Get DNS from ISP?”. Click “Save” button.
Need help?
Do you have a question about the H700 Series and is the answer not in the manual?
Questions and answers