Vertex Standard VX-1210 Service Manual page 13

Programming
r Connect the Microphone Box and Programming Cable of the
SVC-1200 Service Kit to the computer's serial port and the
transceiver's MIC jack.
r Start the CE42 Programming Software, then upload the cur-
rent programming data from the transceiver via the "Read
CH Data" menu, which appears when you press the ([ F4 ] :
Transfer ) key.
r Press the ([ F3 ] : Option ) key to invoke a pop-up window,
select the "Tuner Unit" item, and then change its setting to
"on."
CONNECTION UNIT
Figure 4
Å
Ÿ
Å
Figure 5
MAIN UNIT
Figure 6
ATU-1210 I
Æ
JP
1001
To CNTL UNIT
ATU-1210
Æ
PA UNIT
Cable Tie
(Bandle the Cable)
Installation Manual Reprint
M
NSTALLATION ANUAL
r Press the ([ F3 ] : Option ) key again to close the pop-up win-
dow, then turn on the "Tune Mode" (on the main screen) on
the channel(s) where you wish to operate.
r Download the revised programming data to the transceiver
from the computer via the "Write CH Data" menu, which
appears when you press the ([ F4 ] : Transfer ) key.
r Installation and programming are now complete.
r Disconnect the Programming Cable from the transceiver's
MIC jack.
CNTL UNIT
Figure 7
13