Starting Engine - Kunz AcrEase C60K, H60T, H60B, E60B Owner's Manual

4. Adjust the cutting he
vehicle mower. Adjust each corner of the wing mower so that the distance form the smoo
surface to the bottom edge of the deck is equal to the cutting height minus 5/16". The mower
blade cutting edge is 5/16" above the lower edge of the deck.
Note: To mow in the lower half of the cutting range, set the front caster axles in the bottom
setting and set the anti-scalp wheels in the top hole. To mow in the upper half of the
cutting range (original factory setting), set the front caster axles in the top setting and
set the anti-scalp wheels in the bottom hole.
N ote: After the cutting height has been set, be sure to tighten the pivot bolts securely to
eliminate free pivoting of the front casters or rear axles. Snug the four bolts just be
the height adjust bolt so the front casters and rear axles can be adjusted up and down
but cannot move from side to side.
D. STARTING ENGINE
Set parking brake on tow vehicle.
Attach wing mower tongue to tow vehicle.
Do not start wing mower unless it is attached to the tow vehicle.
For Models H60T & C60K:
Set the choke to the desired position.
Set the throttle lever in the start position at about half throttle. The mower blades clutch will
engage as the engine comes up to speed. The mower blades clutch engages at 1850 RPM
Start engine and allow engine to warm up.
Adjust the choke to off.
Adjust engine speed to full throttle to fully engage the mower blades clutch.
Clutch overheating or failure may occur if engine is not run at full speed in heavy
load conditions.
The engine full speed setting with mower blades running is 3350 RPM.
F or Model H60H:
Set the throttle lever in the choke position to set the choke. (The choke is located beyond the
full throttle detent position.)
ight on the wing mower so that it cuts at the sam
8
e height as the tow
th
yond
.