Tire Pressure - Kunz AcrEase C60K, H60T, H60B, E60B Owner's Manual

I. LUBRICATION
There are up to ten lubrication points on the wing mower -- one spring-loaded idler pivot, two
caster wheel pivots, four wheels (on models that apply), and three blade spindles (on models that
apply). Lubricate at approximately 10 hr. intervals or more often as required in dusty conditions.
Lubricate the blade spindles 2-5 pumps every 50 hours. (The bearings have trash guard seals to
hold the seals in place during lubrication.) Lubricate with a high grade of pressure gun grease.
Note: Do not over grease blade spindles. Blade spindles are initially greased at the factory.
Greasing before 50 hrs. may cause bearing seal damage which will result in premature
bearing failure.
J. TIRE PRESSURE
To reduce wing mower bounce on rough yards, the rear tire pressure can be reduced so they feel
slightly soft (approximately 15 PSI) when they are stepped on.
K. TRANSPORTATION OF MOWER
When transporting the mowers between jobs turn off the fuel shut-off valve. On Models H60T,
H60H and C60K the fuel shut-off valve is located below the fuel tank. On the Model E60B the fuel
shut-off valve is located along the right side of the engine.
L. STORAGE
If the mower is stored outside, the engine should be covered to prevent water from getting inside
the engine during heavy rainstorms. See the Engine Manual for additional information.
15