Related Manuals for Steel City 55150
Summary of Contents for Steel City 55150
- Page 1 ® User Manual Read and understand this manual before using machine. 6”x 9” BELT & DISC SANDER WITH STAND Model Number 55150 STEEL CITY TOOL WORKS VER. 01.02.14...
-
Page 4: Specifications
Operating Instructions Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions for future reference. - Page 5 SAFETY 7. Keep children out of workplace. 4. Do not force a tool. It will work General Safety Information (Continued) Make workshop childproof. Use pad- most efficiently at the rate for which locks, master switches or remove it was designed. BE PREPARED FOR JOB switch keys to prevent any uninten- 5.
-
Page 6: Sander Assembly
SANDER ASSEMBLY Assembly 5. Locate table in desired position and 1. Install foot by pressing onto all four legs. secure with handles. Refer to Figures 3, 4 and 5. 2. Attach one top frame to one pair of 6. Be sure the gap between the disc and Do not attempt legs using carriage bolts and hex disc table is 1/16”... -
Page 7: Mounting Sander To Stand
MOUNTING SANDER TO STAND MOUNTING SANDER TO STAND Refer to Figure 9. 1. Install sander on the stand. 2. Align mounting holes on sander with slots on top frame. 3. Secure sander to stand on all four corners using hex head bolts, hex nuts, and flat washers. -
Page 8: Electrical Information
ELECTRICAL INFORMATION All electrical connec- EXTENSION CORDS tions must be per- 1. The use of any extension cord will cause some drop in voltage and loss POWER SOURCE of power. The motor is designed for operation on 2. Wires of the extension cord must be Normal loads will be handled safely on and maintain adequate voltage. - Page 9 OPERATIONS Operation of anypower tool canresult in foreign objects being throwninto eyes which can result in severe eye damage. Always wear safety goggles complying with instructions (shown on package) before commencing power tool operation. Safety goggles are available through your Grainger catalog. Always observe the following safety precautions: 7.
- Page 10 ABRASIVE BELT FINISHING ADJUST BELT ASSEMBLY POSITION Refer to Figure 10. Refer to Figure 10. 1. Finishing flat surfaces: Hold work- Sanding belt assembly can be adjusted piece firmly with both hands; keep from horizontal to vertical position. fingers away from abrasive belt. 1.
- Page 11 After sanding wood REPLACING ABRASIVE DISC USING MITER GAUGE or non-metallic Refer to Figure 10. material, always clean dust collector 1. Remove disc table and dust chute. and guards of sawdust before grinding 1. The miter gauge is used on both belt metal.
-
Page 12: Troubleshooting Chart
TROUBLE SHOOTING CHART 1. If fuse is blown, replace with fuse of Motor will not start 1. Blown line fuse or tripped circuit breaker proper size. If breaker tripped, reset it 2. Low line voltage 2. Check power supply for voltage and correct as needed 3. - Page 13 DATE MAINTENANCE PERFORMED REPLACEMENT COMPONENTS REQUIRED...
- Page 14 DATE MAINTENANCE PERFORMED REPLACEMENT COMPONENTS REQUIRED...
- Page 15 ® STEEL CITY TOOL WORKS www.steelcitytoolworks.com 1-877-SC4-TOOL (1-877-724-8665)
Need help?
Do you have a question about the 55150 and is the answer not in the manual?
Questions and answers