Cleaning The Air Filter (Lc4 Enduro); Cleaning Of Air Filter (Lc4 Supermoto) - KTM ENDURO 640 LC4 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE
38
3
4
B
1
3
2
5
5
A
6

Cleaning the air filter (LC4 Enduro) *

It is very important for the engine's life expectancy to clean the air filter
regularly.
To clean the air filter, remove screws [1] and the filter box cover. Detach retain-
ing clip [2] and remove the air filter [3] including the filter holder [4] from
the filter box.
Remove the air filter from the filter holder and wash thoroughly in special
cleaning fluid. Motorex offers environmentally-friendly products for professional
oil filter maintenance (Motorex Bio Dirt Remover + Motorex Liquid Bio Power).
Press out the water from the air filter but do not wring and allow the filter to
dry. Lubricate the dry air filter thoroughly with highgrade filter oil, rubbing to
coat the entire filter surface.
Clean the filter box and cover and check the carburetor connection boot for
damage.
Mount the air filter on the filter holder, position in the filter box (make sure
to center) and fix with the retaining clip. Check whether the air filter is posi-
tioned correctly and mount the filter box cover.
– DO NOT CLEAN AIR FILTER WITH FUEL OR PETROLEUM SINCE THESE WILL
DAMAGE THE FOAM. KTM RECOMMENDS THE PRODUCTS MADE BY TWIN AIR
FOR AIR FILTER MAINTENANCE. FOR CLEANING PURPOSES AND TO OIL THE
AIR FILTER.
– NEVER START YOUR MOTORCYCLE WITHOUT ANY AIR FILTERS. OTHERWISE,
DUST AND DIRT MAY PENETRATE AND CAUSE DAMAGE AND INCREASED WEAR.
– DUST AND DIRT CAN ACCUMULATE AND DAMAGE THE ENGINE IF THE AIR FIL-
TER IS NOT MOUNTED CORRECTLY.

Cleaning of air filter (LC4 Supermoto) *

To do this, remove the seat and the air filter cover from the air filter box. Unclap
the filter holder [5], swing back and remove air filter plus filter carrier from
the filter box.
Remove the air filter from the filter holder and wash thoroughly in special
cleaning fluid. Motorex offers environmentally-friendly products for professional
oil filter maintenance (Motorex Bio Dirt Remover + Motorex Liquid Bio Power).
Press out the water from the air filter but do not wring and allow the filter to
dry. Lubricate the dry air filter thoroughly with highgrade filter oil, rubbing to
coat the entire filter surface.
Clean the filter box and cover and check the carburetor connection boot for
damage.
Mount the air filter on the filter support [6]. Grease the front side [A] of the
filter, to improve the seal. Mount the air filter and the filter support in the fil-
ter box. Make sure they are centered [B], and lock into place with the filter
holder [5].
– DO NOT CLEAN AIR FILTER WITH FUEL OR PETROLEUM SINCE THESE DAM-
AGE THE FOAM. KTM RECOMMENDS THE PRODUCTS OF THE COMPANY
„MOTOREX" FOR AIR FILTER MAINTENANCE.
– NEVER OPERATE YOUR MOTORCYCLE WITHOUT AIR FILTER. OTHERWISE,
DUST AND DIRT MAY GET INTO THE ENGINE AND LEAD TO INCREASED WEAR.
– HAVING MOUNTED THE AIR FILTER, CHECK IT FOR CORRECT FIT. THE FRONT
END A MUST ABOUT THE AIR FILTER BOX. OTHERWISE, DUST AND DIRT MAY
GET INTO THE ENGINE AND LEAD TO INCREASED WEAR.
»