TROUBLESHOOTING
TROUBLE
The battery is discharged
No values are visible in the
multi-functional digital
speedometer display.
The speed indication on the
multifunctional digital
speedometer is not working
The blink code indicates which component is affected by an error. This allows the error to be identified if no diagnosis tool is available.
BLINK CODE
SIGNAL / COMPONENT
02
Pulse generator
06
Throttle sensor
07
Sensor for 2nd throttle valve
09
Intake manifold air pressure for sensor rear cylinder
11
Intake manifold air pressure sensor for front cylinder
»
CAUSE
The ignition (power consumer) has-
n't been switched off
The battery isn't charged by the
generator
Blown fuse
Pickup cable is damaged or con-
tacts on the cable connector have
oxidized
REMEDY
Recharge the battery according to the relevant instructions.
Voltage regulator and generator should be checked by an
authorized KTM workshop.
Replace fuse HORN BRAKELIGHT SPEEDO.
Check the pickup cable for damage, visit an authorized KTM
workshop
ERROR DESCRIPTION
Malfunction
Output signal too low /high
Output signal too low /high
Output signal too low /high
Output signal too low /high
75
ENGINE
Stalls
Continues to run
Continues to run
Continues to run
Continues to run