Installing Your; Connecting The Distiller To The Waterline - Pure Water A-12 Owner's Manual

INSTALLING YOUR A-12
Select an area that will allow the Pure Water A-12 to remain level. Improper leveling could affect
the production rate.
Electrical requirements: Isolated 115 to 120 Volt AC, 20 Amp circuit (220 to 240 Volt AC, 10 Amp
on some models). Check the electrical rating on the label on the rear of the distiller.
When connecting the tubing into the quick-connect fittings, it is critical the tubing be inserted
fully! The tubing should insert into the fitting 1/2"-3/4". Failure to do so could result in the
tubing being released when the line is pressurized with water. This could cause water damage.
We recommend that prior to inserting the tubing, you mark the tubing 1/2" from the end being
inserted into the fitting, then pull back on the tubing to verify it is attached securely to ensure the
tubing is properly and fully installed.
The distiller must be located in close proximity to a water supply, floor or other drain and
appropriate electrical supply source. The distiller should also be located in a well-ventilated
room.
CAUTION: The A-12 is rather heavy (66 pounds). Follow these instructions to prevent injury.
a) Carefully remove the A-12 from the carton and remove the parts kits.
Note: You may wish to save the carton and packing materials for future use in the unlikely event
your distiller should require sending to a service center for repair.
A. CONNECTING THE WATERLINE
Note: The use of softened water for the raw water supply is recommended to minimize scale
build-up in the boiling tank.
Note: The A-12 comes standard with a saddle tapping valve. In some jurisdictions a saddle
tapping valve may not be permitted. In such instances, contact your authorized Pure & Secure,
LLC Distributor for other waterline connection options.
CAUTION: DO NOT USE HOT WATER LINE.
CAUTION: DO NOT TURN THE HANDLE BEFORE OR WHILE INSTALLING THE SADDLE
TAPPING VALVE. BE SURE THE PIERCING LANCE DOES NOT PROTRUDE BEYOND THE
RUBBER GASKET.
Locate the parts kit bag identified "Raw Water Hookup Kit".
b) Turn the household water supply off.
c) Install the saddle tapping valve on the COLD water copper tubing so the outlet is in a
convenient direction.
Page 5