Setting The Clock; Activating/Deactivating The Display Modes - KTM 125 SX Owner's Manual

SPEED/TRP2 (trip 2) display mode
The TRP2 trip meter is always active and counts to 999.9. Contrary to
TRP1, the displayed figure can be changed using the + and – buttons. This
is a very useful function for trips taken according to a roadbook.
TRP2 is activated by the first impulse received from the wheel sensor and
stops automatically 3 seconds after the last impulse is received.
+ increases the TRP2 figure
BUTTON
– decreases the TRP2 figure
BUTTON
press the MODE to change to the next mode
BUTTON
press and hold the MODE
BUTTON
SPEED/AVS2 (average speed 2) display mode
AVS2 shows the average speed based on the TRP2 and STP2 figures. The
calculation of this figure is activated by the first impulse received from the
wheel sensor and stops 3 seconds after the last impulse is received.
The displayed figure will deviate from the actual average speed if TRP2 was
changed manually or if STP2 was not stopped after the trip.
+ no function
BUTTON
– no function
BUTTON
press the MODE to change to the next mode
BUTTON
press and hold the MODE
BUTTON
SPEED/STP2 (stop 2) display mode
STP2 is a manual stop watch. Start the stop watch by pressing the + but-
ton, press again to hold. Press again to continue timing.
Press the MODE button to change to the next mode. The STP2 display will
blink in the other modes if STP2 continues to run in the background. To
stop STP2, return to the SPEED/STP2 mode and press the + button.
+ starts and stops the stop watch
BUTTON
– no function
BUTTON
press the MODE to change to the next mode
BUTTON
press and hold the MODE
BUTTON

Setting the clock

To set the clock, switch the ignition off and select the SPEED/CLK mode.
Press and hold the MODE button for 3 seconds. The blinking digits can be
changed using the + and – buttons. Press the MODE button to move to the
next digit.
If no button is pressed for 20 seconds, the settings will be stored automati-
cally and the display will return to the SPEED/CLK mode.
+ time +
BUTTON
– time –
BUTTON
press the MODE to change to the next digit
BUTTON
press and hold the MODE
BUTTON
the SPEED/CLK mode

Activating/deactivating the display modes

It may not be necessary to display all of the display modes (functions) at the
same time. It is possible to conceal any information not currently required.
By deactivating certain functions, the MODE button will only allow you to
select from the activated modes.
In the SPEED/H mode, press and hold the MODE button for 3 seconds to
access the SETUP menu. The blinking function can be activated by pressing
the + button and deactivated by pressing the – button.
If no button is pressed for 20 seconds, the setting will be stored automati-
cally and the display will return to the SPEED/H mode.
+ activates the blinking display
BUTTON
– deactivates the blinking display
BUTTON
press the MODE to change to the next display without changing
BUTTON
any settings
press and hold the MODE
change to the SPEED/H mode
3 to reset TRP2 to 0
SECONDS
3 to change to the next mode
SECONDS
3 to reset STP2 figures to 0
SECONDS
3 to store the time and return to
SECONDS
3 to store the settings and
BUTTON SECONDS
9