Table of Contents
Advertisement
Available languages
Available languages
Initial Settings
Note
• If seek tuning is performed in 50 kHz steps,
stations may be tuned in imprecisely. Tune in
the stations with manual tuning or use seek
tuning again.
Setting the AM tuning step
The AM tuning step can be switched between 9
kHz, the preset step, and 10 kHz. When using
the tuner in North, Central or South America,
reset the tuning step from 9 kHz (531 – 1,602
kHz allowable) to 10 kHz (530 – 1,640 kHz allow-
able).
1 Press
to select
AUDIO
Press
repeatedly until
AUDIO
the display.
tuning step with 2/3.
2 Select the
AM
Pressing 2/3 will switch the AM tuning step
between 9 kHz and 10 kHz. The selected AM
tuning step will appear in the display.
Switching the auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using external equipment connected to this
unit.
1 Press
to select
AUDIO
Press
repeatedly until
AUDIO
the display.
on or off with 5/∞.
2 Select
AUX
Pressing 5/∞ will switch
off and that status will be displayed.
.
AM STEP
appears in
AM 9
.
AUX
appears in
AUX
between on and
AUX
Other Functions
Setting the time display on or off
You can turn the time display on even when the
sources are off.
Press
to select the time display.
CLOCK
Each press of
turns time display on or
CLOCK
off.
• The time display disappears temporarily when
you perform other operations, but the time indi-
cation is displayed again after 25 seconds.
Using the AUX source
An IP-BUS-RCA Interconnector such as the
CD-RB20 or CD-RB10 (sold separately) lets you
connect this unit to auxiliary equipment featur-
ing RCA output. For more details, refer to the
IP-BUS-RCA Interconnector owner's manual.
Selecting AUX as the source
Press
to select
SOURCE
Press
until
SOURCE
AUX
• If the auxiliary setting is not switched on,
cannot be selected. For more details, see
Switching the auxiliary setting on this page.
as the source.
AUX
appears in the display.
AUX
En
16
Advertisement
Table of Contents
