Table of Contents
Advertisement
Section 4 - Advanced
Schedule:
Use the drop-down menu to select the time schedule that
the IPv6 firewall rule will be enabled for. The schedule may
be set to Always, which will allow the particular service to
always be enabled. You can create your own schedules in
the Maintenance > Schedules section.
Source:
Use the Source drop-down menu to specify the interface
that connects to the source addresses of the firewall rule.
Interface
Choose if the rule applies to a LAN or a WAN interface for
the IP addresses in the rule.
IP Address Range:
Enter the source IP address range.
Destination:
Use the Destination drop-down menu to specify the interface
that connects to the destination IP addresses of the firewall rule.
Protocol:
Select the protocol of the firewall port (All, TCP, UDP, or ICMP).
Port Range:
Enter the first port of the range that will be used for the firewall
rule in the first box and enter the last port in the field in the
second box.
New Schedule:
Click this button to create a new schedule.
D-Link DIR-140L User Manual
60
Advertisement
Table of Contents
