Hegel H80 User Manual page 6

GENERAL USE – Remote Control
The top four rows of buttons are Hegel system remote control functions that can be used to control most
Hegel amplifiers and CD-players. Functionality may differ from model to model. The bottom two rows are
designated DAC and computer controls (for the H80).
Remote control buttons (starting top left)
16. Input source selector button for Hegel DAC's
17. Volume Down button. Pressing and holding will decrease the output volume of Hegel DAC's
18. Volume Up button. Pressing and holding will increase the output volume of Hegel DAC's
Input:
To change the selected input on your H80 amplifier you can use the IN+ (1) and IN- (4) buttons, to browse
through the different inputs. When the unit is turned On/Off, it will remember its last input state.
Volume control:
The attached RC9 remote control has two separate sets of volume control buttons. To adjust the output
volume levels on the H80, you need to use the buttons to the top right. UP (3) and DOWN (6).
Computer controls:
The SKIP (13 and 15) and PLAY (14) buttons on the remote control allow you to maneuver the playlist in
most media players. The funtionality will normally not require any software installation, but it does require
that the computer is connected to the H80 with a USB cable.
1. Switches up to next input on your Hegel amplifier
2. Mute for Hegel amplifiers
3. Volume up for Hegel amplifiers
4. Switches down to previous input on your Hegel amplifier
5. ECO – will put certain Hegel equipment in low power mode (sleep)
6. Volume down for Hegel amplifiers
7. Filter selection button for HD25 and certain other Hegel products
8. Stop/Eject for Hegel CD-players
9. Display on/off for certain Hegel products
10. Skip to previous track on Hegel CD-players
11. Play. Starts playback on Hegel CD-players
12. Skip to next track on Hegel CD-players
13. Skip to previous track on most computers/media players
14. Play/Pause on most computers/media players
15. Skip to next track on most computers/media players