Maintenance And Cleaning - Defy DAD 284 Instruction Manual

Maintenance & Cleaning
Always disconnect the plug from the
•
mains socket
appliance. Remember that turning the
thermostat to "0" does not switch the
power off to the unit.
Clean the inside of the appliance
•
whenever necessary using a solution of
warm water and Bicarbonate of Soda.
( 1 table spoon per 2 litres of water ).Dry
with a soft cloth.
Do not use pot scourers or abrasive
•
powders to clean the appliance.
Spillages, especially citric and acidic
•
juices, must be wiped up immediately
as they could stain the product.
Always ensure that the defrost drain,
•
below the back wall evaporator in the
refrigerator compartment , is clean and
free of obstructions.
Shelves and freezer baskets, where
•
fitted, may be removed for cleaning
purposes.
The back of the unit may be vacuumed
•
or dusted using a soft bristle brush.
A mild furniture polish may be used on
•
the exterior cabinet to add lustre and
protect against finger marks.
Replacing the light bulb (Model 1)
1. Unplug the power cord at the wall
socket
2. Remove the thermostat control knob
(A) by carefully prying it out with a
small, flat-bladed screw driver.
3. Unhook the bottom catch (B) by pulling
the lamp cover down and forwards..
4. Simultaneously depress the side tabs
(C) and pull the lamp cover free.
5. Unscrew the faulty bulb and fit a
replacement bulb available from all
Defy Service Centres.
6. To re-assemble the lamp cover, first
locate the bottom catch (B) and then
snap the cover back into place.
7. Fit the thermostat knob, ensuring that
the flat of the shaft aligns with the flat of
the knob-spigot.
PAGE 11
before cleaning the
Replacing the light bulb. (model 2 3)
1. Unclip the light cover by gently pulling
the rear edge forward.
2. Unscrew the bulb and replace it with a
new bulb ( not exceeding 15 watts ).
3. Replace the light cover by inserting the
clip on its front edge into the slot of the
thermostat housing and then snapping
in the clip on the rear edge.
Owner's responsibility
Since the following are not factory faults they
are the owners responsibility:
Damage to the exterior finish.
•
Breakage of glass and other components.
•
Replacement of light bulbs.
•
Damage caused through improper use of
•
the appliance.
Damage caused by moving the appliance.
•
Blocked
•
section).
defrost drain (refrigerator