Panasonic WJ-HDE300 Instruction Manual page 23

Setting/Changing hard disk mode after
resetting error
It is impossible to change or set up the hard disk mode
when the ERROR indicator and one of HDD access
indicators is lit red or is blinking. To set or change the
mode, repair the system so the indicators go out.
Refer to Troubleshooting of this manual and the operat-
ing instructions of the digital disk recorder for details.
Important:
• When an HDD indicator is lit or blinking red, the
HDD is faulty and should be replaced performing
the following steps.
• When less than three hard disks are mounted or the
mounted positions are wrong in RAID5, the HDD
indicators will blink red and be lit red. Add hard
disk(s) or correct the positions and then set up the
extension unit again.
• When the ERROR indicator is lit red and all HDD
access indicators are lit red and orange, it is a sys-
tem error. Consult your dealer.
1 SAFETY MODE ON
Select ON for HDD Safety Mode on the SETUP MENU
and press the SET button.
SETUP MENU
System Recording
Advanced
Switcher Display
1
REC Rate
160GB 160GB
MAIN
Disk Info 15000h 15000h
160GB 160GB
EXT1
Version Info 15000h 15000h
160GB 160GB
EXT2
Disk End Mode
15000h 15000h
160GB 160GB
EXT3
Disk Capacity
15000h 15000h
160GB 160GB
EXT4
Date Delete
15000h 15000h
160GB 160GB
EXT5
15000h 15000h
160GB 160GB
EXT6
Event Log
15000h 15000h
160GB 160GB
EXT7
Error Log
15000h 15000h
Access Log
■
Warning for Disk Life Time
■
Quick Menu
HDD Safety Mode
Event Schedule
LIVE
Comm Maintenance
2 3 4
Remaining
Normal REC Area 1800GB
160GB 160GB Event REC Area 1200GB
15000h 15000h
Copy Area 1000GB
160GB 160GB
1
Copy (Rear) 1000GB
15000h 15000h
160GB 160GB 2
Copy (Front) 1000GB
15000h 15000h
160GB 160GB
15000h 15000h
160GB 160GB
15000h 15000h
160GB 160GB
15000h 15000h
160GB 160GB
15000h 15000h
30000h
ON
SET
→ The recorder will restart and the HDD SAFETY
MODE window will be displayed.
2 Replacement of faulty HDD
• Confirm that the HDD POWER indicator on the front
panel of the extension unit has gone out.
• Replace the faulty
■ Replacing/Mounting HDD.
• Go to the next step below after finishing the con-
nection of the front cover harness with the unit while
the switches and buttons remain operable (step 11
of ■ Replacing/Mounting HDD).
3 Initialization
1 Set the MODE switch to SINGLE.
2 While holding down the RECOVER button, press the
RESET button.
3 While holding down the RECOVER button, release
the RESET button about 1 second later.
4 Release the RECOVER button after the HDD
POWER indicator turns on.
HDD
POWER
HDD
POWER
hard disk referring to
MODE
SINGLE RAID5
ERROR
RESET
MODE
SINGLE RAID5
3
HDD 2
POWER
HDD POWER
Press Release
OFF ON
OPERATE RECOVER
2
4
Hold Release
23