Panasonic WJ-HDE300 Instruction Manual page 16

Setup to the RAID5 mode
Perform the following to set up the unit to the RAID5 mode
for the first time.
1 Power OFF
Confirm that the power of the recorder and the exten-
sion units are turned off.
2 RAID5
Set the MODE switch inside the front lid of the extension
unit to RAID5.
3 Turn on the power switch of the extension units.
4 Turn on the power switch of the recorder.
→ The recorder will start.
5 HDD SAFETY MODE OFF
"HDD SAFETY MODE" menu will open after completing
the system check. Select OFF on the menu and press
the SET button on the recorder's front panel.
→ The recorder will restart.
16
Notes:
6 HDD DISK MENU will appear when the system check is
completed.
Perform formatting on the menu.
Refer to "■ Formatting the Hard Disk" of the operating
instructions of the recorder.
MODE
SINGLE RAID5
POWER
SET
• It will take about 3 or 5 minutes to complete the sys-
tem check.
• When the system has been already run, "HDD
SAFETY MODE" menu will not appear. Skip to step
6.
HDD DISK MENU
Digital Disk Recorder
WJ-HD300A TOP MENU THE CANDIDATE FOR A FORMAT
ALL UNIT ONE UNIT
-
MAIN
480GB
EXT1
480GB
EXT2
480GB
EXT3
*(480GB)
EXT4
ADD (480GB)
EXT5
480GB
EXT6
LOST
EXT7
RETURN: [ SETUP/ESC ] OK : [ SET ]