Panasonic WJ-HDE300 Instruction Manual page 10

2-2 Slide the front cover to the left.
2-3 Pull the front cover toward you.
2 - 3
2 - 2
2-4 Disconnect the harness.
2 - 4
2-5 Remove the six screws (marked with ∆) and detach
the thin metal plate covering the front side.
2 -5
2-6 Disconnect the cables when adding or replacing
the HDD.
2 - 6
10
2 - 3
3.
Remove two of the HDD mounting brackets.
• Remove the four screws and pull the brackets toward
you.
• When replacing an HDD, remove it from the bracket.
4.
Prepare the HDDs to be fixed on the brackets.
• Release the static electricity from your body before
touching the HDDs.
• Put the conductive bag (in which the HDD was packed)
on a soft surface and place the HDD on it with the cir-
cuit board side down.
5.
Fix the HDDs on the brackets.
5-1 Slide the HDD onto the bracket.
5-2 Tighten the four screws (supplied) to fix the HDD on
the bracket.
5-3 Repeat above steps to fix all the HDDs on the
bracket.
Do not use an electric screwdriver to fix them.
Recommended tightening torque = 0.49 N · m
{5 kgf · cm}
6.
Set all the HDDs as master using the jumper connector.
Note: This setting is subject to change without notice.
Refer to the diagram attached on the HDD or the
operating instructions of the HDD for the jumper
connector assignment.