Changing Access Hours In A Keybox - Supra eKey Handbook

6. Press enter.
7. Enter the current shackle code when prompted.
8. Enter the new shackle code when prompted.
9. Re-enter your new shackle code when prompted.
10. Insert the back of your eKEY into the KeyBox so that it fits snugly
into the KeyBox receptacle. The gold contacts on the eKEY must
match the contacts on the KeyBox. An Operation Successful
message appears in the display screen if the new shackle code is
changed successfully. If you receive an error message see Appendix
A: Error Codes for help in determining how to correct the error.
Important! You can use your new shackle code right away, however
you must eSYNC before the new shackle code is recorded
in KIMnet.

Changing access hours in a KeyBox

Access hours, established by your Association/Board/MLS, are
programmed into each KeyBox when the KeyBox is manufactured.
Contact your Association/Board/MLS to determine the timed access
hours programmed into your KeyBox.
Access hours are set at Standard Time (ST). If your area participates in
Daylight Savings Time (DST), it is important to remember that access
hours are one hour later during DST than the pre-set access hours for
the KeyBox. For example, if KeyBoxes are programmed to open
between 8
AM
to 10 .
AM PM
You can change your KeyBox to allow access during the programmed
times (timed access) or to allow access 24 hours a day. You can also
change the programmed access hours.
Note: If you change the programmed access hours, be sure to record
the change in the KeyBox Inventory function in the eDATA
Page 72
and 9 (ST) during DST, the actual access hours are 9
PM
Using the eKEY Application