Set Up To Print - Graphic Products DuraLabel PRO 300 Quick Start Manual

5.

SET UP TO PRINT

When printing labels it is easier to start with an existing template and make modifications than to
create a new label from scratch. On the CD splash screen click on "Install Templates & Symbols."
**IMPORTANT**
document you wish to print.
Continuous Label Stock
The Default Printing Preferences on your
DuraLabel PRO 300 should be at the proper
settings for printing on continuous vinyl and
should require no adjustments.
To change settings:
1. Select START >> PRINTERS and FAXES.
2. Right-click on "DuraLabel PRO 300" and
select "Printing Preferences."
3. On the Options tab you can adjust the
speed and darkness to optimize print quality depending on the ribbon and
tape supply you are using.
Die-Cut Label Stock
When printing on die-cut labels you will need to calibrate the gap sensor and
make some adjustments in the print driver.
To calibrate the gap sensor:
1. Turn off the printer and wait 5 seconds.
2. Hold down the button on top of the printer
and turn it back on. The light will change
colors then blink red 5 times.
3. Release the button while it's blinking red.
Labels will feed through the printer
and the gap sensor will be calibrated.
To set up the driver for die-cut label stock:
1. Select START >> PRINTERS and FAXES.
2. Right-click on "DuraLabel PRO 300" and
select "Printing Preferences."
3. On the Stock tab under "Media Settings" change the Type to "Labels with
Gaps."
(If you do not want to cut between every label, under Media Handling change
the Post-Print Action to "None." Or you can leave the cutter on but specify an interval.)
4. Click "Apply" after you have made your changes.
Perform these changes before opening the
(Arc Flash & RTK/NFPA)
- 9 -