Conformity Of Use; Way Of Functioning - Roller Grill SGM 600 Instructions For Use And Installation

Nomenclature SGF 800
Spare parts SGF 800
Rep Code Qty
1 F01005 1 Grille à poignée
2 F01068 1
3 72065 1
4 A14077 1
5 E02031 1
6 F02007 2 Glissière plat
7 E02195 1 Raccord alimentation
8 E02037 1 Raccord union 3/8
9 A13006 4
10 72056 1 Fond socle
11 73006 1
12 E02157 1 Bouchon raccord
13 E01011 2
14 E02181 2 Injecteur GN (150)
E02182 2 Injecteur BP (100)
15 E02160 2 Porte injecteur
16 E02201 1 Thermocouple
17 E02032 1 Veilleuse
17.1 E02086 1 Injecteur veilleuse GN (45)
18 E02230 1 Ensemble tubes cuivre
19 72055 1 Fond arrière
Pièce Spare part
Handle grid
Grille Grid
Plat Tray
Bouton Knob
Robinet Tap
Tray slide
Link alimentation
Fitting 3/8
Pied Foot
Bottom casing
Toit Roof
Stopper
Radiant Burner
Injector GN (150)
Injector BP (100)
Injector holder
Thermocouple
Pilot light
Pilot light injector GN
Copper pipes assembly
Back casing

3. CONFORMITY OF USE

Use the device only to defrost, brown, glaze, grill toasts, gratins, pizzas, onion
soups.

4. WAY OF FUNCTIONING

These salamanders exist in 11 versions (3 gas versions and 8 electric versions)
SALAMANDERS WITH MOVABLE TOP
Salamanders SGM 600 and SGM 800 are respectively fitted with two infrared burn-
ers with safety thermocouple, a removable inside tray.
The top of the salamander is movable and enables you to adapt the cooking position
to grill, glaze or brown your foodstuffs.
FIXED SALAMANDERS
Salamander SGF 800 is fitted with two infrared burners with safety thermocouple, a
removable inside tray, two racks enabling to adjust the grid with handles on 3 levels
to adapt cooking position.
To turn on the device, just approach a long matchstick or gas lighter near the pilot
light located under the top (n°2 on picture), press and turn the control knob (n°1 on
picture) in front of star position.
Keep the control knob (n°1 on picture) pressed for 15 seconds. The burner then re-
mains lit.
While cooking, the temperature can be regulated using the control knob (n°1 on pic-
ture) from high flame to low flame in order to avoid over-cooking.
A safety thermocouple cuts the gas supply if one of the burner is extinguished. In
this particular case, just turn on the device again as explained before
The low flame of the appliance is pre-adjusted in the factory, it must not be changed.
14 3