Additional Installation Requirements - Miele TKG 640 WP Operating Instructions Manual

Installation and connection
Additional installation
requirements

For safety reasons the tumble
dryer must be disconnected from the
electricity supply before installation.
Building under a continuous
worktop/in a row of kitchen units

It is very important to avoid a
build-up of heat. The warm air which
is expelled from the dryer must be
able to dissipate. Warm air which
cannot dissipate could cause a fault.
– The electrical socket must be located
in an accessible position near the
appliance.
– Drying durations may increase
slightly.
A build-up of heat can be avoided by:
– Adjusting the screw feet so that there
is a gap of at least 20 mm between
the floor and the bottom of the dryer.
– Creating a gap for the dryer in the
kitchen furniture plinth facing.
– Creating ventilation gaps in the
kitchen unit.
Pushing the dryer under a worktop
This tumble dryer is suitable for
pushing under a worktop if there is
space to do this without removing the
lid.
64
Optional accessories
– Building-under kit

A building under kit is required if
the lid of the tumble dryer needs to
be removed in order to build it under
a worktop.
It must be installed/dismantled by a
suitably qualified fitter.
The lid of the tumble dryer is replaced
by the cover plate supplied with the
building under kit. It must be fitted by a
suitably qualified fitter to ensure
electrical safety.
Fitting instructions are supplied with the
building-under kit.
– Washer-dryer stack
The tumble dryer can be combined with
a Miele washing machine in a washer-
dryer stack. The appropriate Miele
washer-dryer stacking kit is required.
– Plinth
The tumble dryer can be fitted on a
plinth with drawer (please note the
plinth may not be available in all
countries).