Table of Contents
Advertisement
If an existing hole is not conveniently located for passing the power ca-
ble through the fire wall, drill a hole and insert the rubber grommet pro-
vided. Leave at least 18 inches of slack in the plug end of the cables next to
the radio. A typical cable routing diagram is shown in Figure 4.
MOUNTING THE RADIO
The radio should be mounted within convenient reach of the operator.
Mount the radio where it will not interfere with the safe operation of the ve-
hicle or cause a hazard to passengers in case of an accident. Refer to Figure
5 for details on securing the mounting bracket.
The mounting bracket may be placed over or under the radio housing de-
pending on the mounting location. Additionally, the radio may be tilted
within the mounting bracket to allow the best viewing angle.
POWER CABLE INSTALLATION
Power connections to the radio are made through a three-wire power ca-
ble assembly (Figure 6).
10
Figure 5 - Installing Mounting Bracket
Advertisement
Table of Contents
