Important Radio Notes; Maintenance; Cleaning - DeWalt DCR015 Instruction Manual

AC OUTLETS (FIG. 6)
The charger/radio is equipped with 2 AC outlets (S)
for powering additional tools or appliances.

Important Radio Notes

1. Reception will vary depending on location and
strength of radio signal.
2. Running the radio while connected to certain
generators may cause background noise.
3. AM reception will most likely be clearer when
powered by a battery pack.

MAINTENANCE

WARNING: To reduce the risk of injury, turn unit off and
disconnect it from power source before installing and removing
accessories, before adjusting or when making repairs. An
accidental start-up can cause injury.

Cleaning

WARNING: Blow dirt and dust out of all air vents with clean, dry air
at least once a week. To minimize the risk of eye injury, always wear
ANSI Z87.1 approved eye protection when performing this.
WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC
outlet before cleaning. Dirt and grease may be removed from the
exterior of the charger using a cloth or soft non-metallic brush. Do not
use water or any cleaning solutions.
DeWalt electric
FIG. 6
S
Power tools