Section 4: Principal Components; Section 5: Installation - Franke filterflow Zurich filter system Installation Manual

Section 4:
principaL componentS
Section 5:
inStaLLation
Shut off the mains water supply
install the stop valve
Install the stopvalve (H) in the chosen position in the adjacent
15mm pipework.
note. For DIY installation a self piercing valve is available as an
alternative to the stop valve; visit www.FrankeFilterFlow.co.uk
Secure the filter housing bracket
Unscrew the housing head (D) and separate it from the sump (F).
Mark the positions for the two bracket supporting screws (J). Screw
in both screws, leaving their heads protruding approximately 3mm
to allow the bracket (E) to be easily lifted on and off the screws.
4
A 3/8" x 3/8" Push-fit connector
B 3/8" Plastic Tube-Blue
C 3/8" Push-fit Elbow
D Filter Housing Head
E Bracket
F Filter Housing Sump
G Inlet Hose
Stop Valve 15mm comp x 1/2"
H
BSPM
J Wood Screws x 2
K 'O' Seal for Filter Sump
L
L Filter Cartridge
Zurich Tap Supplied Separately
9.03001
9.03110
9.03400
N/A
N/A
N/A
9.28001
9.13001
9.24001
9.07663
Franke 02 (Franke 01 in
Republic of Ireland)