Vision TZ58/1800-10 Installation, Operation And Maintenance Manual page 3

Vision Solar Systems - 100 L Gravity Fed Type
The Electrical Element should be connected by a qualified electrician
registered with the Electrical Contractors Board. This will insure that a
correct and safe installation is completed.
Ensure that all electrical connections are kept dry and protected from
the ingress of water and moisture.
The installation should be performed or under the control of a
qualified person in terms of The National Building Regulations and
any additional regional requirements as set out by Local Building
Regulations
Try and use a plumber who is registered with the Plumbers
Registration Board (PIRB) AND who has completed the elective
course on Solar Installations, and who is familiar with the product.
The installation must comply with the National Building Regulations,
The National Water Regulations and the Local Water (Plumbing)
Regulations in the area where the installation takes place.
Avoid axial or twisting force on the pipes. Do not use a pipe wrench
on the pipe to tighten the connection. Always hold the pipe when
tightening the connection.
It is important to the operation of the system to use balanced pressure
to any mixing valves on the hot water outlet to prevent back feed into
the system.
We do not recommend connecting mixing valves to the system outlet.
While these systems contain no hazardous materials, it is always good
practice to recycle. Should you need further information, please
contact your local agent.
Copyright © 2013 - 2016 Enervision. All Rights Reserved.
3
Issue 2.0 Mar 2013