Vision TZ58/1800-10 Installation, Operation And Maintenance Manual page 19

Programming the timer
Setting the time
 If there is no display, press and hold the RESET button for a few seconds
Press and hold down the clock button while pressing the D+ button to the desired day of the

week.
 Press and hold down the clock button while pressing the H+ button to the desired hour.
 Press and hold down the clock button while pressing the M+ button to the desired minutes.
Release the clock button when the time and day is set.

Setting the Time Zones
 Press P, Display will show the Time Zone 1 On time.
Use the H+ to set the hour.

 Use the M+ to set the minutes.
 Use the D+ to set the day of the week. Enervision recommends MTWTFSS as default. (cycles
MTWTFSS, MTWTFS, MTWTF, SS, MTW, TFS, MWF, TTS, M, T, W, T, F, S, S)
Press the P again. Display will show Time Zone 1 OFF time.

 Press the H+ to set the hour.
Use the M+ to set the minutes.

Use the D+ to set the day of the week. Enervision recommends MTWTFSS as default.

 Press P again to go to Next Zone and continue from the top, or Press Clock to stop setting
Time zones.
There are a possible 16 time Zones that can be set.
19
Copyright © 2013 - 2016 Enervision. All Rights Reserved.
Issue 2.0 Mar 2013
Vision Solar Systems - 100 L Gravity Fed Type