Table of Contents
Advertisement
RoboPi v1.00
User Manual v0.60
Copyright 2014 William Henning
RoboPi Printed Circuit Board
Here is a top view of where parts are located on the RoboPi printed circuit board:
You can refer to this image while wiring your robot after assembling your RoboPi.
PLEASE NOTE
The "PROPPLUG" connection is for stand-alone RoboPi operation (where RoboPi is NOT stacked on
top of a Raspberry Pi. Pins 1-4 are the same as PropPlug (Pin 1 is GND), Pin 5 adds 3.3V for SerPlug.
Plugging in a PropPlug while RoboPi is stacked on the Raspberry Pi may damage your
Raspberry Pi and/or RoboPi.
http://Mikronauts.com
4
2014-01-27
Advertisement
Table of Contents
