Syscom Video DSP COLOR CAMERA Instruction Manual page 15

4. The observation camera has a ¼"-20 UNC mounting holes located at the
top and the bottom of the camera housing to allow for top or bottom
mounting. Mount the camera on the stand by threading the mounting bolt
into either mounting hole on the camera.
5. Install the lens. If a C- or CS-mount lens is used, adjust the back focal
length or picture focus.
•
For C-mount lenses, rotate the focus adjust ring clockwise.
•
For CS-mount lenses, rotate the focus adjust ring counterclockwise.
6. If an auto-iris lens is used, connect the cable of the lens to the mini-DIN
connector supplied with the camera. Insert the lens connector into the
auto-iris connector on the camera.
7. Route the assembled cable from the monitor location to the camera
location.
8. Plug the cable into the BNC output port labeled VIDEO OUT located on
the back of the camera.
IMPORTANT: The minimum recommended load rating for
the mounting bracket is 11 lbs (5Kg).
IMPORTANT: Do not aim or point the camera towards the
sun or into a strong light.
WARNING: Care should be taken when routing the cable
from the monitor to the camera. Try not to put
unnecessary strain on the cable or connectors. Do not
place the cable next to fluorescent lights as interference
may result. Do not use staples to support the cable as they
may damage the cable. If the provided camera cable is not
long enough, do not substitute a telephone cable as it
could damage the camera and/or the monitor. Contact
your authorized Ultrak dealer/ distributor to purchase
longer cables.
7