Make Connections And Play; Example Connections; Preparing To Play - Korg AmkII Owner's Manual

Make connections and play!

Example connections

Preparing to play

Be sure to turn off the power before making connections. Careless operation may damage your
speaker system or cause malfunctions.
1. Connect the included AC adapter to the DC 9V jack, and plug the adapter into an AC outlet.
As shown in the above diagram, hook the AC adapter cable around the adapter cable holder. When
removing the cable from the holder, do not use excessive force.
2. Connect one end of your audio cables to the Part output jacks of the EA-1
and connect the other end to your mixer. The output of the EA-1
dent for each part, so you will need to make pan adjustments on your mixer. If you wish to mix the
two parts for output, connect your powered monitor speaker (amplified speaker) to the PART1/
MIX jack.
3. If you will be using headphones, connect them to the headphone jack. The headphone output is
monaural.
The output from the Part output jacks will not be switched off even if headphones are plugged in.
4. When you have finished making connections, turn on the power. Slightly raise the master volume
of the EA-1 II, and press the Keyboard function key. Press the step keys to produce sound and
mk
verify that connections have been made correctly. Use the master volume of the EA-1
gain and fader controls of your mixer or powered monitor system to adjust the volume to an
appropriate level.
1.Introduction
II (PART1/MIX, PART2),
mk
II is not stereo, but is indepen-
mk
II and the
mk
7