HP p1543b Installation Manual page 15

Solving Problems
Error Messages
The following table shows some common error messages that may
appear on the screen and possible ways of solving the problem. If
you experience errors when using the CD Recording software, refer
to the application's online help.
Error Message
D:\ or E:\ is not accessible.
The device is not ready.
No CD-RW found
There is no disk in the drive "n",
insert a disk and try again
Access denied
Invalid drive specification
12 English
Suggested Action
1 Check disc is correctly inserted in the drive and
that the disc drawer is closed. Press Retry.
2 The disc may be dirty or damaged. Try another
disc.
3 Check drive cable connections and ensure
drive is correctly installed.
1 If the CD-RW drive is connected to your PC by
the same cable as your primary IDE hard disk,
check that the jumper on the rear of the drive
is set to the SLAVE position.
2 If the CD-RW drive is connected to your PC by
the secondary IDE cable, check that the
jumper on the rear of the CD-RW drive is set
to the MASTER (no other device on same
cable) or SLAVE (other device on cable
configured as MASTER) position.
3 Check the CD-RW data cable and power cable
connections.
Check that the disc in the CD-RW drive is correctly
inserted.
Check that the disc is not already being used by
another application at the same time.
1 Check that the CD-RW is enabled in the PC's
Setup program (refer to page 11).
2 Check that you have selected the correct drive
letter that identifies the CD-RW to your
computer.