Beghelli PLANEX Instruction Manual

INSTRUCTION
PLANEX
L E D L I G H T P A N E L
GRID / SUSPENSION / RECESS / SURFACE
120VAC or 277VAC 50 - 60H
1X1 OR 2X2 CONFIGURATIONS
POWER SUPPLY
SUSPENSION
MOUNT TABS

IMPORTANT SAFEGUARDS

No User serviceable parts. Refer service to a qualified service technician.
Read instructions prior to installing and /or operating this device.
Installation should be performed by a licensed electrician / installer
IMPORTANT SAFETYGUARDS
When using electrical equipment, basic safety precautions should
always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
- Do not let power cords touch hot surfaces.
- Do not mount near gas or electric heaters.
- Equipment should be mounted in locations and at heights where
unauthorized personnel will not readily subject it to tampering.
- The use of accessory equipment not recommended by Beghelli
Inc., may cause an unsafe condition, and will void the warranty.
- Do not use this equipment for other than its intended purpose.
- Servicing of this equipment should be performed by qualified
service personnel.
SAVE THESE INSTRUCTIONS!
CONTACT US
Beghelli Canada Inc.
3900 14th Avenue
Markham, Ontario L3R 4R3 Canada
Tel (905) 948-9500 / Fax (905) 948-8673
www.Beghellicanada.com
111512
TM
INPUT
Z
IR SENSOR PORT OR
0-10V WALL DIMMER PORT
WARNING
in accordance with local codes.
ALUMINUM FRAME
EACH MODEL NUMBER CONSISTS OF THE FOLLOWING:
SERIES / LED COLOR TEMP . / INPUT
LED / COLOR-
LENS DIFFUSER
INSTALLATIONGUARDS
1. Disconnect POWER before installation
2. Verify all parts are accounted for. Check power supply connections.
3. If required, connect the IR Sensor OR the Wall Dimmer to the port as
indicated on the power supply.
4. Connect to VAC following wiring lables.
Lables will indicates:
120VAC or 277VAC 50-60Hz
L (black) Line / Hot
N (white) Neutral / Common
G (green) Ground
5. Network Connection from PRIMARY output to input on SECONDARY unit.
Unit with IR connection or 0-10V Wall Dimmer becomes PRIMARY
automatically.
6. Mounting Options:
a) Grid / T-Bar (secure luminaraire in grid / ceiling T-bar.)
b) Suspension Cable installation (connect suspension cable kit
according to indicated mounting dimensions.
Adjust cables to balance luminaire.)
c) Recess Wall (cut hole in drywall, secure mounting bracket,
connect safety cable, make electrical connection, slide luminaire in place.)
d) Surface mount (assembel 3 sides of frame and mount securely,
insert luminaire, align final section of frame and secure with screws.
7. Turn on power VAC.
Beghelli USA
3250 Corporate Way, Unit A
Miramar, FL 33025 USA
P: (954) 442-6600 / F: (954) 442-6677
www.beghelliusa.com
TM
Series: PLANEX (1'X1') / (2'X2')
WT35 (3500K)
TEMP . WT55 (5500K)
Input 120VAC or 277VAC 50 - 60H
Beghelli MEXICO
Av El Marques No. 70, Interior 4
Parque Industrial Bernardo Quintana
76246 Mpio. El Marquez
Queretano, QRO. Mexico
P: +52 442-221-6439 / F: +52 442-221-6215
www.beghellimexico.com
INPUT
Z