Korg M3 User Manual page 30

Music workstation/sampler, editor / plug-in editor

Hide thumbs Also See for M3:

Table of Contents

data dump requires a certain amount of time, you may wish to shorten the startup time by

using the Load Data File Automatically function instead of this function, or by using the

UTILITY command Load to load a previously-saved data ﬁle into M3 Editor.

Note: The Total Recall & Data Sync Setting function is available only with M3 Plug-In Editor.

Load data ﬁle automatically

When M3 Editor starts up, the data ﬁle you specify here will automatically be loaded into the

editor. After this process is completed, the data you checked in Total Recall & Data Sync Set-

ting will be loaded via data dump.

Auto Local Control

This setting automatically sets the M3's Local Control setting to the appropriate state when

you start up the editor. We recommend that you normally leave this parameter on. The M3's

Local Control setting will be reset to its original state when you close the editor.

Table of Contents

Show Quick Links

Table of Contents