Liftkar PT-S 130 Instruction Manual page 34

Note 2: if the wheelchair had been folded for transport, make sure that it has been set
up properly by simply pressing down sharply on the seat. Otherwise it is possible that
the side frames will not be far enough apart to allow the climber unit to fit between
the lower mountings.
3. Set the lowest speed (see also 4.1.2)
4. Press UP on the UP/DOWN switch
so the climber unit moves upwards
until the upper rods engage with the
yokes on the upper mounting on the
wheelchair (photo 4).
5. Use the quick-release pins to secure
the mountings on the left and right
(photo 5).
Note 3: quick-release pins are often used because they are self-securing due to spring
pressure applied by an inside cone and three small balls which press outwards. Hold the
mushroom head between forefinger and middle finger and press the spring pin down with
your thumb. With the pressure released you can insert the pin into the hole on the
mounting right up to the mushroom head. The quick-release pin locks in place when you
let go of it. M ake sure the quick-release pin is working properly each time you use
it.
6. If you want to use the wheelchair/stairclimber, but not on the stairs, then press
DOWN on the UP/DOWN switch so that the lifting frame retracts (the single-
step control stops it in the right place automatically).
4
5
34
A