Basic Operation - Yamaha YHT-S300 Owner's Manual

BASIC OPERATION
Once you have finished all cable connections and remote control operation, follow the procedure below to start
basic playback operation.
2
3
4
Press one of the input buttons to select
an input source.
Start playback on the selected external
component.
For information on the external component, refer
to the instruction manual for the product.
Press VOLUME +/- to adjust the volume
level.
To turn off the volume temporarily, press MUTE.
While the mute function is activated, the VOLUME
indicator flashes. To resume the volume, press MUTE
again or press VOLUME +/-.
Press _.
This system is turned on and the STATUS
indicator lights green.
This system has the auto-sleep function, which will
automatically switch the system to turn off if the
system is left turned on for 24 hours without any
operation being performed.
When sound of HDMI is output from the TV, the
volume level does not change if you press VOLUME
+/-.
Press _ again to set the system to
standby mode.
When the "HDMI CONTROL" is set to "ON", the
STATUS indicator lights red. When the "HDMI
CONTROL" is set to "OFF", the STATUS indicator
turns off. (_ P. 19)
• Using the remote control
Use the remote control within 6 m (20') of the
subwoofer integrated receiver and point it toward the
remote control sensor.
• Be careful not to spill liquid on the remote control.
• Be careful not to drop the remote control.
• Do not leave the remote control in a place that is:
- hot or humid, such as near a heater or in a bathroom
- extremely cold
- dusty
_a02._ a_2_0_ Within 6 m (20')
12 En