Yamaha YHT-S300 Owner's Manual page 17

• Pairing
About "Pairing"
Pairing must be performed before using a Bluetooth
component with the Yamaha Bluetooth wireless
audio receiver connected to the system for the first
time or if the registered pairing data has been
deleted. "Pairing" refers to the operation of
registering a Bluetooth component for Bluetooth
communications.
To ensure security, a time limit of 8 minutes is set for the
pairing operation. Please read and fully understand all the
instructions before starting.
For details, refer to the instruction manual of Yamaha
Bluetooth wireless audio receiver.
Press DOCK to set the input to DOCK.
Turn on the Bluetooth component you
want to pair with, and then enter pairing
mode.
Refer to the instruction manual of your Bluetooth
component for details.
Press OPTION.
OPTION menu for DOCK input appears in the
display.
4 Press the cursor _ to select "PAIRING"
and press (_) (Center).
"Searching..." appears when the pairing starts.
While the Yamaha Bluetooth wireless audio
receiver is in pairing mode, the DOCK indicator
flashes in the front panel display.
To cancel pairing, press RETURN.
Check that the Bluetooth component
detects the Yamaha Bluetooth wireless
audio receiver.
If the Bluetooth component detects the Yamaha
Bluetooth wireless audio receiver, the audio
receiver name ("YBA-10 YAMAHA" for
example) appears in the device list of the
Bluetooth component.
@
Select the Yamaha Bluetooth wireless
audio receiver in the device list of the
Bluetooth component, and then enter the
pass key "0000" on the Bluetooth
component.
• Establishing a connection
After the pairing is completed, perform the connecting
operation on the system or on the Bluetooth
component to enable communication between them.
The connecting operation on the system is only
available *or the most recently connected Bluetooth
component.
2
3
Press DOCK to set the input to DOCK.
Press OPTION to enter OPTION menu.
"CONNECT" appears firstly in the front panel
display.
Press O (Center).
"Searching..." appears firstly in the front panel
display.
When the system finds the last connected
Bluetooth component, "BT connected" appears in
the front panel display I'or 3 seconds.
• If the system cannot find the last connected Bluetooth
component, "Not found" appears in the front panel
display.
• If you want to establish a connection with a Bluetooth
component other than the one most recently
connected to, connect from that Bluetooth
component. Refer to the instruction manual of your
Bluetooth component for details.
To disconnect the Bluetooth wireless audio receiver from
the Bluetooth component, display OPTION menu again,
select "Disconnected," and press C) (Center).
17 En