Related Manuals for Rime Lite UNION 2
Summary of Contents for Rime Lite UNION 2
- Page 1 USER GUIDE UNION 2 / 4 / 6 Please read this manual before operating UNION, and keep it for future reference.
- Page 2 Index Introduction Intellectual Property Safety Introduction Unpacking Layout Specification Operation Instruction for UNION Operation Instruction for SWING Check list when troubling Replacing lamp and flash tube Accessories Warranty...
-
Page 3: Intellectual Property
All intellectual property, owned by or which is otherwise the property of Rime Lite or its respective suppliers relating to UNION, including but not limited to, accessories, parts, or software, is proprietary to Rime Lite. No title to or ownership in the intellectual property is transferred to you. All... -
Page 4: Safety Instructions
Do not jubject UNION to excessive pressure. Do not touch UNION with wet hands Do not store in dusty areas. Please be aware that Rime Lite clains no responsibility for damage from data loss due to breakdwon, repair, or other causes. - Page 5 Unpacking Your package contains the following items. Power Cable Synchro Cable Halogen MIRA You can obtain the following accessories for from your local dealer: UNION Trigger Receiver SWING SWING...
- Page 6 Layout Cursor Description Cursor Description ① Protecting Glass ⑨ Modeling Lamp Fuse ② Modeling Lamp ⑩ LCD Display ③ Flash Tube ⑪ Synchro Socket ④ Modeling Base ⑫ Digital Encoder ⑤ Umbrella Holder ⑬ Power Switch ⑥ Locking Holder ⑭ Receiver Holder ⑦...
-
Page 7: Specification
SPECIFICATION... - Page 8 Operation Instruction for UNION A. Insert a power cord into the main Inlet. B. Turn the power switch ON C. Before switching off, better to set all buttons & indicators to “Minimum” or “OFF” Adjusting Flash Output 1. How to adjust Flash Power Output - Press Digital Volume once, then you can see below image.
- Page 9 Operation Instruction for SWING Before you use SWING with UNION, please power off strobes. You will experience the great performance of both strobe and SWING. Transmitter - Join the transmitter to a digital camera Receiver - Join the receiver to a strobe. Notice) when a user set the channel of SWING, the user should adjust the same number of both transmitter and receiver.
- Page 10 Check list when troubling 1. Cannot turn on the power. 1) Please check the power switch on. 2) Please check the power cable inserted correctly. 2. Unit does not flash. 1) Please check the flash tube inserted correctly. 2) Please check the trigger coil contacted with the flash tube legs. 3) Please change the flash tube.
- Page 11 Replacing lamp and flash tube You must switch off and disconnect the power cord before changing lamp or flash tube!!
- Page 13 Accessories...
- Page 14 2. Rime Lite’s sole obligations are to the repair of the defective part, or at its discretion, replacement of the product (service exchange unit) 3.