Operating Your Camera
...
V -REV : Use this feature to vertically inverse the screen. Position the indicator over
'V-REV' using the UP or DOWN button and then set to 'ON' using the LEFT
or RIGHT button. Press the SET button to confirm.
...
I MAGE ADJ : Includes image quality or special function factors.
• T ONE : Increasing this value increases the overall brightness.
• S HARPNESS : Increasing this value sharpens object edges. Too high of a setting,
however, produces noise and may obscure the image.
• C OLOR : Adjusting this value affects the chroma level only; the burst level is
unaffected.
...
C OMMUNICATION : Use this feature to select communication protocol (refer to
p.48~ p.53 for details). Position the indicator over
'COMMUNICATION' using the UP or DOWN button.
40
COLOR CCD CAMERA
User's Manual
• CAM ID NO. : Assign an ID number to the camera (1 to 255).
Identification number zero is used for Remote controller setup.
• CAM ID DISP : Displays camera ID on top left corner of the screen.
• BAUD RATE : Configure baud rate from 9600, 19200, or 38400bps.
• UART MODE : Configure parity bit to NON, EVEN, or ODD. Data bit is set to 8bit, and
stop bit to 1bit. Set the UART MODE to EVEN if using the Remote
Controller.
• RETURN PACKET : Used to transfer a packet.
E ND : evert back to the USER PRESET menu.
...
RESET
To reset your camera to factory default condition.
EXIT
To finish setup menu.
COLOR CCD CAMERA
41
User's Manual