Yamaha RX-Z11 Service Manual page 59

FANCNT/FAN speed/MODE
The value of TM1/TM2/TM3 is detected and FAN is
controled.
OUTLVL (Power limiter output level)
Total value of amplifier output of each channel
The voltage at 44 pin of IC100 is displayed.
(Reference voltage: 5V=255)
LMTCNT (Limiter control value)
The voltage at 56 pin of IC100 is displayed.
(Reference voltage: 5V=255)
AMPRELAY (Amp. Power relay control)
The output condition of the power relay of the amplifier
section is displayed.
Display
ON
OFF
11.SYS MONITOR
FAN:41% A/L TO
11.SYS MONITOR
OUTLVL:000
11.SYS MONITOR
LMTCNT:255
11.SYS MONITOR
AMPPON:ON
Q126 (AMPPOW P.C.B.) Q131 (AMPPOW P.C.B.)
ON
OFF
THX fan operation /
TX : Normal
TO : THX mode
Fan operation /
– : STOP
L : LOW (60˚C)
M : (65˚C)
H : HIGH (72˚C)
Fan drive /
Use the "PURE DIRECT" key for selection. /
A : AUTO
– : STOP
L : LOW
M : MID
H : HIGH
Fan control output /
(255=100%)
(FAN_CTRL: 5 pin IC100 SUBCPU P.C.B.)
ON
OFF
RX-Z11/DSP-Z11
59