Operationg Instruction; Name And Function Of Remote Controller - LG universal system air conditioner Service Manual

Ceiling Concealed Duct
8. Operating Instructions

Name and Function of Remote Controller

3
Signal Receiver
5
8
9
10
11
12
13
14
1. Operation display
Displays the operation conditions.
2. On/Off Button
Operation starts when this button is pressed, and stops
when the button is pressed again.
3. Set Temperature Button
Used to set the temperature when the desired temperature
is obtained.
4. FAN Operation Button
Used to circulate room air without cooling or heating.
5. Electric Heater Button(optional)
Used to set the Electric Heater.
6. Fan Speed Button
Used to set desired fan speed.
7. Operation Mode Selection Button
Used to select the operation mode.
• Auto Operation Mode.
• Cooling Operation Mode.
• Soft Dry Operation Mode.
• Heating Operation Mode.(except cooling model)
8. Timer Cancel Button
Used to cancel the timer.
Display temperature can be different from actual room temperature if the remote controller is installed at the
place where sun-rays are falling directly or the place nearby heat source.
58 Universal System Air Conditioner
AUTO SWING OPERATION SET TEMP FAN SPEED
Room Temp
HI AUTO
MED JET
LO
Time
ZONE
Timer Operation unit Program set
On Off
Set no. Time 01 03 05 07 09 11 13 15 17 19
Timer Cancel
Program Week Holiday
Plasma
SET/CLR
Hour Min
RESET
9. Timer Set Button
Used to set the timer when the desired time is obtained.
10. Week Button
11. Program Button
12. Holiday Button
13. Time Set Button
14. Set and Clear Button
15. Room Temperature Checking Button
16. Plasma Air Clean Button(optional)
17. Reset Button
SUB FUNCTION
1
Heater Preheat
Defrost Humidify
Filter Out door
1 2 3 4
21 23
2
6
7
4
15
16
17
Used to set a day of the week.
Used to set the weekly timer.
Used to set a holiday of the week.
Used to set the time of the day and change the time in the
weekly timer Function.
Used to set and clear the weekly timer.
Used to check the room temperature.
Used to set the current time and clear the setting time.